• -

      Power switch LED cable assembly removal movie - ThinkCentre A52 (8288, 8297, 8326, 8329, 8342, 8380)

      Back Power switch LED cable assembly removal movie - ThinkCentre A52 (8288, 8297, 8326, 8329, 8342, 8380) - Videos

      Movie player help

       

      Power switch LED cable assembly installation movie

       

      Text of the audio portion of this movie

      To remove the power switch LED cable assembly:

      1. Remove the side cover.
      2. Remove two rear screws.
      3. Grasp the handle and slide the cover approximately 1/2 inch to the rear.
      4. Rotate the cover out and lift off.
      5. Remove the front bezel. Disconnect the cable for the power switch LED assembly from the system board.
      6. There are three latching tabs on the left side and three hinge tabs on the right side of the bezel.
      7. While applying pressure to the top of the bezel, release each of the three tabs starting with the tabs on the top.
      8. Rotate the left side of the bezel away from the chassis until the hinge tabs are free.
      9. Lift the bezel from the chassis using caution not to damage the power switch LED cable as you pull it through the chassis.
      10. Remove the power switch LED cable assembly.
      11. Grasp each of the LED's and pull them from their sockets.
      12. Release the latches securing the power switch and pull it from the bezel.

       


      Was this information helpful?

      Your feedback helps to improve this site.