Floppy diskette drive installation movie - ThinkCentre A52 (8288, 8297, 8326, 8329, 8342, 8380)

Movie player help


Text of the audio portion of this movie

To install a diskette drive:

  1. Slide the drive into the media drive bay using the screw holes for alignment and secure with the two screws.
  2. Connect the power cable and the signal cable.
  3. Return the system its operational position.
  4. Install the front bezel. Route the power switch LED power cable through the hole in the chassis.
  5. Align the tabs in the bezel with the slots in the chassis and press until secure by the latches. Here is a closer look at a hinge tab on the bezel and a cut-out in the chassis.
  6. Connect the power switch LED cable to the system board.
  7. Install the side cover. Position the cover over the chassis using the tabs on the top and bottom as a guide.
  8. Slide the cover forward until its locked in place.
  9. Secure with the two screws.
  10. Here is a closer look at one of the tabs on the cover and a slot in the chassis.