Unsupported Browser Detected

The Lenovo Support website supports Microsoft Internet Explorer 10+, Mozilla Firefox 29+, Chrome 34+ and any other modern web browser.

      Power supply installation movie - ThinkCentre A51, A52, M52, M52e

      Back Power supply installation movie - ThinkCentre A51, A52, M52, M52e - Videos

      Movie player help

      Power supply removal movie


      Text of the audio portion of this movie

      To install the power supply:

      1. Place the power supply in position and slide it to the rear until it latches in place.
      2. Secure the power supply with the four screws.
      3. Connect the following power cables: P9 - CD-ROM drive, P1 - system board and P2 - system board.
      4. Install the bay 3 and 4 cage assembly. Position the cage assembly using the large flat tab under bay 2 as a guide.
      5. Put pressure on the assembly to press it against bay 2 while sliding the assembly forward until it locks into place. Here’s a closer look at the tabs on the bottom of bay 2 and the slots on the cage assembly.
      6. Install the thumb screw.
      7. Connect the diskette signal cable.
      8. Connect the SATA signal cables to the drive.
      9. Connect the power cables.
      10. Install the side cover. Position the bottom of the cover over the edge of the chassis.
      11. Rotate the cover down while aligning the tabs on the cover with the slots in the chassis.
      12. Slide the cover forward until it is secured in place. Here is a closer look at the cover tab and a slot in the chassis.
      13. Return the system to its operational position.
      Additional information


      ThinkCentre movie index
      Detailed power supply installation and removal instructions for ThinkCentre A51, A52, M52, M52e


      Full service video CD available from http://www.pc.ibm.com/training.

      Purchase parts online

      Was this information helpful?

      Your feedback helps to improve this site.