Unsupported Browser Detected

The Lenovo Support website supports Microsoft Internet Explorer 10+, Mozilla Firefox 29+, Chrome 34+ and any other modern web browser.

      Top case assembly removal and installation - ThinkPad Edge E520, E525

      For access, remove this FRU:

      Removal steps of top case assembly

      Note: Your models may look slightly different from the illustration above.

      Step Screw (quantity) Color Torque
      1 M2x6 mm, wafer-head, nylon-coated (10) Black 0.181 Nm (1.85 kgfcm)


       

      Note: Your models may look slightly different from the illustration above.

      Step Screw (quantity) Color Torque
      2 M2x3 mm, wafer-head, nylon-coated (4) Black 0.181 Nm (1.85 kgfcm)

      Step Screw (quantity) Color Torque
      3 M2×6 mm, wafer-head, nylon-coated (5) Black 0.181 Nm (1.85 kgfcm)

      When installing: Make sure that the connector is attached firmly to the system board.

      In step 6 , push the top case assembly out from the frame by using a plastic pry tool as shown in the following figure.

      Remove the top case assembly in the direction shown by the arrow 7 , and then detach the connector 8 .

      When installing: Make sure that the connector is attached firmly to the system board.

      Purchase parts online

      Was this information helpful?

      Your feedback helps to improve this site.

      • Alias ID:
      • Document ID: PD015277
      • Last Updated :17 Jun 2014
      • © 2016 Lenovo