• -

      Keyboard bezel and power button board removal and installation - ThinkPad Edge E320, E325

      Keyboard bezel assembly and power button board removal and installation instruction

      For access, remove these FRUs in order:

      Please perform the following steps as shown in the pictures below:

      Step
      Screw (quantity)
      Color
      Torque
      [1] M2 × 5 mm, flat-head, nylon-coated (9) Black 0.181 Nm (1.85 kgfcm)

       

      Step
      Screw (quantity)
      Color
      Torque
      [2] M2 × 2 mm, big-head, nylon-coated (2) Bronze 0.181 Nm (1.85 kgfcm)
      [3] M2 × 4 mm, flat-head, nylon-coated (2) Silver 0.181 Nm (1.85 kgfcm)

      Note

      On each of the two flat flex cables, there is a black line. When connecting each of the two flat flex cables into the corresponding ZIF connector, make sure that the black line on the flat flex cable is aligned with the outer edge of the ZIF connector.

      When installing:
      Make sure that the connectors are attached firmly.

      In step [10] , push the top case assembly out from the frame as shown in the following figure by using a plastic pry tool, and remove the top case assembly in the direction shown by the arrow [11] .

      Removal steps of power button board

      Step
      Screw (quantity)
      Color
      Torque
      [1] M2 × 3 mm, flat-head, nylon-coated (1) Black 0.181 Nm (1.85 kgfcm)

       

       

       

       

      Was this information helpful?

      Your feedback helps to improve this site.

      • Alias ID:
      • Document ID: PD015158
      • Last Updated :17 Jun 2014
      • © 2015 Lenovo