Unsupported Browser Detected

The Lenovo Support website supports Microsoft Internet Explorer 10+, Mozilla Firefox 29+, Chrome 34+ and any other modern web browser.

      Completing the FRU replacement - ThinkCentre M57 (type 6008, 6068, 6074, 6079, 6082, 9012, 9018, 9087, 9096, 9163, 9172, and 9193)

      After replacing FRUs, you need to install any removed parts, replace the cover, and reconnect any cables, including telephone lines and power cords. Also, depending on the FRU that is replaced, you might need to confirm the updated information in the Setup Utility program.

      Note: When the power cord is first plugged in, the computer might appear to turn on for a few seconds and then turn off. This is a normal sequence to enable the computer to initialize.

      1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left inside your computer.
      2. Reposition any cables that might impede the replacement of the computer cover.
        Important: Correctly route all power supply cables to avoid interference with the drive bay assembly. Keep cables clear of the hinges and sides of the computer chassis.
      3. Position the computer cover on the chassis so that the rail guides on the sides of the cover engage the rails and push the cover to the closed position until it snaps into position.

      Position the cover.

      1. If the cover is secured with thumbscrews, install them.
      2. Reconnect the external cables and power cords to the computer. See "Rear connectors".
      3. If you have replaced the system board, you must update (flash) the BIOS. See "Updating (flashing) BIOS from a CD-ROM or diskette".
      4. Some FRU replacements require the configuration to be updated. See, "Using the Setup Utility" in the User Guide.
      Purchase parts online


      Was this information helpful?

      Your feedback helps to improve this site.

      • Alias ID: MIGR-68721
      • Document ID: PD011062
      • Last Updated :17 Jun 2014
      • © 2016 Lenovo