Unsupported Browser Detected

The Lenovo Support website supports Microsoft Internet Explorer 10+, Mozilla Firefox 29+, Chrome 34+ and any other modern web browser.

      Replacing the front panel card - ThinkCentre M57 (type 6068, 6074, 9172, 6008) / M57p (type 9087, 9193, 9018, 9012)

      To replace the front panel card, do the following:

      1. Remove cover. See "Cover removal".
      2. Remove the drive bay assembly. See "Accessing system board components and drives".
      3. Disconnect the front panel assembly cables from the system board. See the system board illustration for your machine type at "System board connectors".
      4. Remove the screw that secures the front panel card assembly to the chassis.

      Remove the screw that secures the front panel card.

      1. Note the front panel assembly cable routing and remove the assembly from the chassis.
      2. Route the cable for the new front panel card assembly through the hole in the chassis and to the system board.
      3. Install the front panel card assembly into the chassis and secure it with the screw.
      4. Connect the front panel assembly cables to the system board.
      5. Align the drive bay assembly with the two slots and rails on the sides of the chassis and slide the drive bay assembly towards the rear of the chassis until it snaps into position.
      6. Reinstall the front bezel.
      7. Go to "Completing the FRU replacement".
      Purchase parts online


      Was this information helpful?

      Your feedback helps to improve this site.

      • Alias ID: MIGR-68711
      • Document ID: PD010807
      • Last Updated :17 Jun 2014
      • © 2016 Lenovo