• -

      Base cover assembly removal and installation - ThinkPad X200, X200s, X200si, X201, X201i, X201s

      For access, remove these FRUs in order:

      X200, X201, and X201i base cover assembly removal and installation

      Please perform the following steps as shown in the pictures below.

      Remove the top shielding assembly at first.
      X200, X201, and X201i base cover assembly removal and installation
      X200, X201, and X201i base cover assembly removal and installation

      X200, X201, and X201i base cover assembly removal and installation
      X200, X201, and X201i base cover assembly removal and installation

      X200, X201, and X201i base cover assembly removal and installation
      X200, X201, and X201i base cover assembly removal and installation

      In step [5] and [6], remove the system board, the DC-in connector, and the fan assembly together from the base cover assembly. X200, X201, and X201i base cover assembly removal and installation

      When installing: Make sure that the position of the wireless switch [a], and firmly fit into the base cover assembly.

      Note: Following step is only for ThinkPad X201 and X201i.

      X201 and X201i base cover assembly removal

      Cable routing: Route the speaker cable as shown in this figure.

      X201 and X201i base cover assembly removal

      X200s, X200si and X201s base cover assembly removal and installation

      Please perform the following steps as shown in the pictures below.

      Remove the top shielding assembly at first.
      X200s, X200si and X201s base cover assembly removal and installation
      X200s, X200si and X201s base cover assembly removal and installation

      X200s, X200si and X201s base cover assembly removal and installation
      X200s, X200si and X201s base cover assembly removal and installation

      X200s, X200si and X201s base cover assembly removal and installation
      X200s, X200si and X201s base cover assembly removal and installation

      In step [6] and [7], remove the system board, the DC-in connector, and the fan assembly together from the base cover assembly.
      X200s, X200si and X201s base cover assembly removal and installation

       

      Applying labels to the base cover

      The new base cover FRU is shipped with a kit containing labels of several kinds.
      When you replace the base cover, you need to apply the following labels:

      [1] Product label
      [2] Homologation label
      [3] Non-mercury label
      Note: If the computer you are servicing is an LED-backlight LCD model, you need to paste this label so that the notice for mercury is covered.

      Following labels need to be peeled off from the old base cover, and need to be put on the new base cover.

      [3] Windows license label (COA)
      [4] Serial number label
      [5] MAC address label
      [6] IMEI label
      [7] FCC-ID label for Wireless LAN
      [8] FCC-ID label for Wireless WAN
      [9] China modem label
      [10] SIRIM label

      For some models, you need to apply one or two FCC labels, [7] or [8]. Check the old base cover; if it has one or two FCC labels, find duplicates of them in the label kit and apply them to the new base cover.

      For the location of each label, refer to the following figure:

      Base cover labels

       

      Purchase parts online

      Was this information helpful?

      Your feedback helps to improve this site.

      • Alias ID: MIGR-71247
      • Document ID: PD005501
      • Last Updated :17 Jun 2014
      • © 2015 Lenovo