For access, remove these FRUs in order:
|1||M2 × 3 mm, wafer-head, nylon-coated (2)||Black||0.181 Nm (1.85 kgfcm)|
|3||M2 × 10 mm, wafer-head, nylon-coated (4)||Black||0.181 Nm (1.85 kgfcm)|
- Before you attach the fan assembly to the computer, apply thermal grease, at an amount of 0.2 grams, on the parts marked [a] as in the following figures. Either too much or too less application of grease can cause a thermal problem due to imperfect contact with a component. For the fan in the integrated graphics models, you need to peel the thin film off from the thermal rubber marked [b].
For Discrete graphics models:
For Integrated graphics models:
- When attaching the fan assembly to the frame, take care not to damage the heat sink ([a]) of the fan assembly.
- Make sure that the fan connector is attached firmly.