Unsupported Browser Detected

The Lenovo Support website supports Microsoft Internet Explorer 10+, Mozilla Firefox 29+, Chrome 34+ and any other modern web browser.

      Base cover assembly and DC-in cable removal and installation - ThinkPad Edge 13

      For access, remove these FRUs in order:

      74523_basecover00_view.jpg

      Cable routing: Make sure that the cable is attached to the cable guides as shown in this figure. When you route the cables, make sure that they are not subjected to any tension. Tension could cause the cables to be damaged by the cable guides, or a wire to be broken.

      74523_basecover01_view.jpg

      Note: Applying labels to the base cover:

      The new base cover FRU is shipped with a kit containing labels of several kinds. When you replace the base cover, you need to apply the following labels:

      [4] Information label under battery

      [6] FCC label

      [7] Homologation label

      [13] Serial number blank label

      Following labels need to be peeled off from the old base cover, and need to be put on the new base cover.

      [1] Ethernet label

      [2] Windows license label (COA)

      [3] SID card label

      [5] SIM ICCID label

      [8] Brazil ANATEL wireless LAN label

      [9] Israel label

      [10] Israel label

      [11] China wireless WAN label

      [12] Brazil ANATEL Bluetooth label

      [14] Wireless WAN label

      [15] Wireless LAN label

      For some models, you also need to apply one or two FCC labels. Check the old base cover; if it has one or two FCC labels, find duplicates of them in the label kit and apply them to the new base cover.

      For the location of each label, refer the following figure:

      74523_basecover02_view.jpg

       

      Purchase parts online

      Was this information helpful?

      Your feedback helps to improve this site.

      • Alias ID: MIGR-74523
      • Document ID: PD003657
      • Last Updated :17 Jun 2014
      • © 2016 Lenovo