• -

      DC-in connector, fan, digitizer pen case, and pen switch assembly removal and installation - ThinkPad X200 Tablet, X201 Tablet

      For access, remove these FRUs in order:


      DC-in connector, fan, digitizer pen case, and pen switch assembly removal

      Please perform the following steps as shown in the pictures below.

      Remove the top shielding assembly at first.

      Hardware removal step 1 and 2
      Hardware removal step 1 screw description

      Hardware removal step 3

      Hardware removal step 4
      Hardware removal step 4 screw description

      In step [6] and [7], remove the digitizer pen case assembly.

      Hardware removal step 5, 6 and 7Hardware removal step 5 and 6 screw description

      Hardware removal step 8
      Hardware removal step 8 screw description

      Hardware removal step 9, 10 and 11

       

      DC-in connector, fan, digitizer pen case, and pen switch assembly installation

      When installing: Make sure that the position of the wireless switch, and firmly fit into the frame [b].

      Turn the system board over, and then disconnect the DC-in connector, the fan connector, and the pen switch connector from the system board.

      Hardware installation step 12, 13 and 14

      When installing: Make sure that the DC-in connector, the fan connector, and the Pen switch connector are attached to the system board firmly.

      Hardware installation step 15, 16, 17, 18 and 19
      Hardware installation step 18 screw description

      When installing:

      • Before you attach the fan assembly to the computer, apply thermal grease, at an amount of 0.2 grams, on the part marked [a] as in the following figure. Either too much or too less application of grease can cause a thermal problem due to imperfect contact with a component. You need to peel the thin film off from the rubber [b].

      For ThinkPad X200 Tablet:

      Fan installation figure

      For ThinkPad X201 Tablet:

      dcin_x201t.jpg

       

      • Make sure that the fan connector is attached firmly.
      Purchase parts online

      Was this information helpful?

      Your feedback helps to improve this site.

      • Alias ID: MIGR-71445
      • Document ID: PD003438
      • Last Updated :17 Jun 2014
      • © 2015 Lenovo