|Monitor Size||15.0-inch (381.0 mm)|
|Viewable image size||15.0-inch (381.0 mm)|
|Maximum viewable area||228 mm x 304 mm|
|Contrast ratio (typical)||600 : 1|
|Brightness (typical)||250 cd/m2|
|Horizontal viewing angle||150 degrees (at 10:1 contrast ratio)|
|Vertical viewing angle||130 degrees (at 10:1 contrast ratio)|
|Response time (typical)||8 ms|
|Pixel pitch||0.297 mm|
|Bezel width||19 mm|
|Kensington Lock slot||Yes|
|Signal cable - analog||1.5 m|
|SYNC on Green||No|
|Analog Video Connector||15-pin D-Sub|
|Native resolution||1024 x 768|
|Preset display modes||12|
|User defined display modes||7|
|VESA DDC capable||2B|
|Power management capable||Yes - VESA DPMS|
|Power supply||Universal Voltage (100 to 240 Vac)|
|Power cord||1.8 m (detachable)|
|Tilt stand adjustment||5 degrees forward, 20 degrees backward|
|FCC B compliance||Yes|
|MPR-2 Emission compliance||No|
|MPR-3 Emission compliance||No|
|TCO'99 Environmental Label||Yes|
|EU Directive 2002/95/EC (RoHS)||Yes|
|Height||13.64-inch (346.5 mm)||16.73-inch (425.0 mm)|
|Width||13.57-inch (344.6 mm)||16.06-inch (408.0 mm)|
|Depth||6.3-inch (160.0 mm)||5.12-inch (130.0 mm)|
|Weight||6.38 lb (2.9 kg)||9.02 LB (4.1 kg)|
- Input voltage: 100 to 240 V ac +/- 10% (universal voltage)
- Frequency: 50/60 Hz
- Power consumption:
- Maximum: <23 watts
- Normal use: <23 watts typical
- VESA standby: <2 watts
- VESA suspend: <2 watts
- VESA off: <1 watts at 100 V ac
- Maximum earth leakage current:
- <3.5 mA at 264 V
- <0.25 ma at 100 V
Actual power consumption depends on the chosen display mode, the images displayed, and user control settings.
|Operating||10 to 35 deg. C||10 to 80 %||0 to 9,842 ft (3,000 m)|
|Shipping||-20 to 60 deg. C||5 to 95 %||0 to 14,763 ft (4,500 m)|
|Storage||-20 to 60 deg. C||5 to 95 %||0 to 9,842 ft (3,000 m)|
Declared acoustical noise emissions LWAU = 4.5 bels or less. The noise emission level stated is the declared (upper limit) A-weighted sound power level, in bels, for a random sample of monitors. All measurements are made in accordance with ANSI S12.10 and reported in conformance with ISO/DIS 7779.
- One monitor
- Attached tilt stand that can be removed
- Attached 1.5-meter (4.92-foot) analog video signal cable (15-pin D to 15-pin D) that can be removed
- Attached 1.8-meter (5.9-foot) audio signal cable
- Power cord
- CD containing multilingual user's guide, setup test pattern, and Windows installation file
- Setup poster
- Safety, troubleshooting, and warranty information
Note: With the exception of the models for U.S., Canada, and Japan, the power cords (based on the country order code) are supplied by distribution centers.
Three years - Customer Carry-in or Mail-in using Rapid Replacement Service
- Announce date: 11 Mar 2008 (Brazil)
- Planned availability date: 14 Mar 2008 (Brazil)
The Lenovo D153 monitor operates with system units or video adapters that generate a video output signal falling within the monitor's specifications:
|Native Resolution||1024 x 768 pixels|
|Maximum pixel rate||80 MHz|
The monitor supports VESA Standard Timings as detailed in "Display Monitor Timing Specification," V1.8, dated September 17, 1998, for the following modes:
- VGA: 640 x 480 at 60, 66, 72, and 75 Hz
- SVGA: 800 x 600 at 60, 72, and 75 Hz
- XGA: 1024 x 768 at 60, 70, and 75 Hz
This monitor supports the following modes:
- 640 x 350 at 70 Hz
- 720 x 400 at 70 Hz
Note: National language support is a function of the video adapter in the system unit and the application or support software.
(H x V Pixels)
|Incoming video refresh rate|
|640 x 350||70 Hz NI|
|640 x 480||60 Hz NI|
|66 Hz NI|
|72 Hz NI|
|75 Hz NI|
|720 x 400||70 Hz NI|
|800 x 600||60 Hz NI|
|72 Hz NI|
|75 Hz NI|
|1024 x 768||60 Hz NI|
|70 Hz NI|
|75 Hz NI|
The preset modes cannot be overwritten, but can be adjusted to personal choice. The new settings are stored automatically in one of the user locations and are recalled each time that mode is used. The factory settings for the mode in use, if any, can be restored by operating the reset control.
Information about the current incoming display mode is shown in the on-screen displays. However, it is displayed at the LCD panel's optimum refresh rate of 60 Hz.It may be necessary to make some adjustments to the displayed image to compensate for variations in video signal timings. The user controls can be used to make these adjustments.
- Microsoft Windows Me
- Microsoft Windows 2000
- Microsoft Windows XP
- Emissions: TCO'99
- Power management: ENERGY STAR 4.0 (United States)
- EU Directive 2002/95/EC (RoHS)
- Software: Windows Hardware Logo Program
- UL (United States)
- IEC950 CB Report (International)
- TUV-S (Argentina)
- FCC B (United States)
- Supported display modes are a function of the attaching system unit and video subsystem. The full range of display modes available with these monitors may not be available or supported with all combinations of system units, their operating systems, video adapter cards, and application software.
- Horizontal- and vertical-synchronization signal timings are critical in order to achieve acceptable screen images. As a consequence, support for all possible variations in H- and V-sync timings for any display mode cannot be assumed.
- Adjustment of the user controls to enlarge the image to its maximum size requires that the signal timings of the display mode being used fall within the monitor-timing specifications.
- This monitor provides FCC class B - residential installation - compliance in all display modes.
- Implementation of monitor power management follows the VESA DPMS standard. This standard must also be implemented in the attaching system unit hardware and software for monitor power management to be effective. The system implementation must provide user-adjustable, power-down delay periods. The monitor power management function is invoked only after appropriate signals are received from an attached system unit or video adapter.
- Implementation of monitor Plug and Play follows the VESA DDC standard. This standard must also be implemented in the attaching system unit hardware and software for monitor Plug and Play to be effective.
- Certain functions require the system unit to be similarly configured, so all monitor functions may not be enabled when attached to a particular system unit.
- A 15.0-inch (381.0 mm) flat-panel LCD monitor has nearly 2.4 million subpixel transistors laid over an area exceeding 107 square inches. Cost-effective manufacturing processes introduce a small number of defective subpixel transistors. The Lenovo D153 meets ISO 13406-2 Class II Pixel defect standard.
- Use of 50% background is not recommended since some users may see undesirable visual effects on the screen.
- The Auto-Setup "test pattern" can be used with Windows 98, Windows 2000, Windows XP, and DOS 7.0 only.