Unsupported Browser Detected

The Lenovo Support website supports Microsoft Internet Explorer 10+, Mozilla Firefox 29+, Chrome 34+ and any other modern web browser.

      Palm rest or palm rest with fingerprint reader removal and installation - ThinkPad X200, X200s, X200si, X201, X201i, X201s

      Palm rest removal

      For access, remove these FRUs in order:

      In models with the fingerprint reader, the sensor is attached to the palm rest FRU. If the fingerprint reader has any defects, you can replace it by the procedures given in this section, which are the same for a palm rest with or without a fingerprint reader.

      Please perform the following steps as shown in the pictures below.

      Palm rest removal step 1
      Palm rest screw description

      Note: Step [2] is only for models with the fingerprint reader. For models without the fingerprint reader, skip step [2].
      Palm rest with Fingerprint reader removal

      Palm rest removal step 3

      Palm rest installation
      1. In models with the fingerprint reader, attach the fingerprint reader connector firmly to the system board.
      2. Press the left and right top edges of the palm rest to fit it into place.
      3. Push the front side of the palm rest until it clicks into place.
        Palm rest installation
      4. Close the LCD cover and turn the computer over. Then fasten the five screws to secure the palm rest.
      Purchase parts online


      Was this information helpful?

      Your feedback helps to improve this site.

      • Alias ID: MIGR-71232
      • Document ID: PD000693
      • Last Updated :17 Jun 2014
      • © 2016 Lenovo