지원되지 않는 브라우저가 발견되었습니다

Lenovo 지원 웹사이트는 Microsoft© Internet Explorer 10+, Mozilla Firefox 29+, Chrome 34+ 지원합니다

      Replacing the hard disk drive - ThinkCentre M90z

      This section provides instructions on how to replace the hard disk drive.

      To replace the hard disk drive, do the following:

      1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the computer.
      2. Remove the computer cover. See Removing the computer cover.
      3. Locate the hard disk drive in the computer. See Component locations.
      4. Pull the handle 1 of the hard disk drive bracket upward and then slide the hard disk drive outward to remove it from the hard disk drive bay.

      Removing the hard disk drive

      1. Flex the sides of the hard disk drive bracket properly to remove the hard disk drive out of the bracket.
      2. To install the new hard disk drive into the bracket, flex the bracket and align pin 1, pin 2, pin 3, and pin 4 on the bracket with the corresponding holes in the hard disk drive. Do not touch the circuit board 5 on the bottom of the hard disk drive.

      Installing the hard disk drive into the bracket

      1. Align the four pins 1 on the hard disk drive bracket with the corresponding slots in the hard disk drive bay.

      Installing the hard disk drive

      1. Slide the new hard disk drive with the bracket into the hard disk drive bay. Press the handle of the hard disk drive bracket downward until it is secured by the two tabs 1.

      Installing the hard disk drive

      1. To complete the installation or replacement, see Completing the parts replacement.

       

      Search

      이 정보가 도움이 되셨습니까??

      귀하의 피드백이 이 사이트를 개선시키는데 도움을 줍니다..

      • Alias ID: MIGR-75322
      • Document ID: HT035979
      • 최종 업데이트 :17 Jun 2014
      • © 2016 Lenovo