지원되지 않는 브라우저가 발견되었습니다

Lenovo 지원 웹사이트는 Microsoft© Internet Explorer 10+, Mozilla Firefox 29+, Chrome 34+ 지원합니다

      Replacing the Bluetooth module - ThinkCentre M90z

      Note: The Bluetooth module is available only in some models.

      To replace the Bluetooth module, do the following:

      1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the computer.
      2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay it down so that the screen is against the surface and the cover is facing up.
      3. Remove the computer cover. See Removing the computer cover.
      4. Remove the rear I/O assembly cover. See Removing the rear I/O assembly cover.
      5. Locate the Bluetooth module in the computer. See Component locations.
      6. Note the Bluetooth module cable routing and disconnect the cable from the system board.
      7. Carefully release the Bluetooth module and lift the Bluetooth module out of the computer.

      Removing the Bluetooth module

      1. Position the new Bluetooth module into the computer front bezel and then press the new Bluetooth module downward until it is secured into place.
      2. Connect the new Bluetooth module cable to the system board. See System board part and connector locations.
      3. Reinstall the rear I/O assembly cover. See Removing the rear I/O assembly cover.
      4. To complete the installation or replacement, go to Completing the parts replacement.

       

      Search

      이 정보가 도움이 되셨습니까??

      귀하의 피드백이 이 사이트를 개선시키는데 도움을 줍니다..

      • Alias ID: MIGR-75327
      • Document ID: HT035951
      • 최종 업데이트 :17 Jun 2014
      • © 2016 Lenovo