The optional hard drive mounting bracket can easily be pivoted upward or removed if necessary to enable replacement of some CRUs and FRUs.
Note: There appears to be two drive bays in the bracket. However, due to thermal restrictions, only the bay (2) at the rear of the chassis can be used to install a hard drive.
- To pivot the optional hard drive bracket upward, pull outward at the bottom of the bracket.
Note: You might have to disconnect the cables attached to the optional hard drive.
- If it is necessary to remove the optional hard drive mounting bracket, disconnect the cables attached to the optional hard drive, remove the two screws, and lift the bracket out of the chassis.