Print
login Account
Search

System board, DC-in connector cable, and ExpressCard slot assembly removal and installation - ThinkPad T410, T410i

For access, remove these FRUs in order:

Important notices for handling the system board:

When handling the system board, bear the following in mind.

  • The system board has an accelerometer, which can be broken by applying several thousands of G-forces.

    Note: Dropping a system board from a height of as little as 6 inches so that it falls flat on a hard bench can subject the accelerometer to as much as 6,000 G's of shock.

  • Be careful not to drop the system board on a bench top that has a hard surface, such as metal, wood, or composite.
  • If a system board is dropped, you must test it, using PC-Doctor for DOS, to make sure that the HDD Active Protection still functions (see below).

    Note: If the test shows that HDD Active Protection is not functioning, be sure to document the drop in any reject report, and replace the system board.

  • Avoid rough handling of any kind.
  • At every point in the process, be sure not to drop or stack the system board.
  • If you put a system board down, be sure to put it only on a padded surface such as an ESD mat or conductive corrugated material.

After replacing the system board, run PC-Doctor for DOS to make sure that HDD Active Protection still functions. The procedure is as follows:

1. Place the computer on a horizontal surface.
2. Run Diagnostics --> ThinkPad Devices --> HDD Active Protection Test.

Attention: Do not apply physical shock to the computer while the test is running.

Following components soldered on the top side of the system board are extremely sensitive. When you service the system board, avoid any kind of rough handling.

[a] CPU
[b] Accelerometer chip for the HDD Active Protection System™
[c] PCH (Platform Controller Hub)
[d] GPU (Graphic Processing Unit): Discrete graphics chip

Note: GPU ([d]) is only for the Discrete Graphics models. Integrated Graphics models do not have GPU on the system board.

For Discrete Graphics models:

74756_sysboard_00_view

For Integrated Graphics models:

74756_sysboard_01_view

74756_sysboard_02_view

Step Screw (quantity) Color
Torque
1 M2 × 10 mm, wafer-head, nylon-coated (2) Black 0.181 Nm (1.85 kgfcm)
2 M2 × 5 mm, wafer-head, nylon-coated (1) Black 0.181 Nm (1.85 kgfcm)

74756_sysboard_03_view

When installing: Make sure that the connector is attached firmly.

Purchase parts online