제품 정보를 입력하면, 맞춤형 서비스를 이용할 수 있습니다.
제품이 선택되지 않았습니다.제품을 선택하십시오.
Built-in only Display mode cannot be maintained after reboot - ThinkCentre, ThinkStation, ThinkServer, ThinkPad, IdeaPad, IdeaCentre
Symptom

The built-in only Display mode cannot be maintained after rebooting the system.

Affected configurations

The above symptom is associated with, but not limited to, the following systems:

  • ThinkCentre
  • ThinkStation
  • ThinkServer
  • ThinkPad
  • IdeaPad
  • IdeaCentre

The system is configured with:

  • Any system installed with a DisplayLink USB graphic card driver and using a USB monitor.

 

Applies To:

  • Microsoft Windows 7
  • Microsoft Windows Vista
  • Microsoft Windows XP

Additional Information:

This behavior is working as designed.  All DisplayLink devices have the same behavior.  If the user configures the USB monitor to turn off, then unplugs it and then plugs it into system, the monitor will remain off.  The reboot behavior is the same as unplugging and then plugging-in again.

To re-enable the monitor, see the Solution section below.

Solution

The user should configure the monitor from the Driver menu after rebooting the system.

Limitations

The built-in only Display mode cannot be maintained after rebooting when using the ThinkVision LT1421 wide screen.

Workaround

None



원하시는 내용을 찾을 수 없는 경우, 아래의 방법을 시도해 보십시오:
1. Lenovo 검색
2. 제품 사용 방법 및 일반적인 문제해결 방법
3. Lenovo 지원 포럼
4. 기술 지원 콜센터

국가 상태
사용 가능Worldwide
가명 아이디 : SF12-D0195
문서 자료 ID : HT075084
Legacy Document ID : SF12-D0195
마지막 업데이트 : 11 Sep 2013
© 2013 Lenovo. All rights reserved.
   
Select Task
 
Drivers & Software  
Guides & Manuals  
Diagnose & Fix  
Warranty & Services  
Parts  
Accessories  

추가 자료
도움말 인덱스
제품 사양 - PSREF
드라이버 목록
새로 배포된 드라이버 (RSS)
커뮤니티
커뮤니티 기술자료
커뮤니티 포럼
Windows 8 Support