제품 정보를 입력하면, 맞춤형 서비스를 이용할 수 있습니다.
제품이 선택되지 않았습니다.제품을 선택하십시오.
System may not resume in Standby mode - ThinkCentre M90z
Symptom

The system may not resume when in Standby mode.

Affected configurations

The above symptom is associated with, but not limited to, the following systems:

  • ThinkStation M90z

Applies To:

  • All Operating Systems

The system is configured with:

The symptom may occur with the following two conditions together:

  • System Board part number is 0B03608, and
  • Embedded Controller firmware version is 9BCT32A (see BIOS Setup to confirm)
Solution

Do not replace any hardware for this issue.  User should update the Embedded Controller (EC) firmware to version 9BCT33A, or greater.

User should update to BIOS version 9BKT41A before installing new EC firmware. 

Click here to below download BIOS version 9BKT41A.

Follow the instructions below to update the Embedded Controller (EC):

  1. Download the flash from operating system ThinkCentre M90z BIOS package 9BJY41USA.exe from Lenovo support website.
    NOTE: Only 9BJY41UAS, or above, BIOS contains EC version 33A.
  2. Run 9BJY41USA.exe and extract files to a folder.  The default folder is C:\SWTOOLS\FLASH\9BJY41USA.
  3. Navigate to the folder where the files were extracted.  Run the flash.cmd to update the BIOS to 9BKT41A.  Using administrator privileges, run ec.cmd to flash EC firmware up to 9BCT33A.  Do not power off system flashing EC firmware.  The system must reboot after flashing new EC firmware.
  4. The EC version can be checked in the BIOS setup screen.  NOTE: The BIOS version and EC firmware version may not match.

 

 



원하시는 내용을 찾을 수 없는 경우, 아래의 방법을 시도해 보십시오:
1. Lenovo 검색
2. 제품 사용 방법 및 일반적인 문제해결 방법
3. Lenovo 지원 포럼
4. 기술 지원 콜센터

국가 상태
사용 가능Worldwide
문서 자료 ID : HT072425
마지막 업데이트 :
© 2013 Lenovo. All rights reserved.
   
Select Task
 
Drivers & Software  
Guides & Manuals  
Diagnose & Fix  
Warranty & Services  
Parts  
Accessories  

추가 자료
도움말 인덱스
제품 사양 - PSREF
드라이버 목록
새로 배포된 드라이버 (RSS)
커뮤니티
커뮤니티 기술자료
커뮤니티 포럼
Windows 8 Support