제품 정보를 입력하면, 맞춤형 서비스를 이용할 수 있습니다.
제품이 선택되지 않았습니다.제품을 선택하십시오.
Installing or replacing a memory module - ThinkCentre M90z

This section provides instructions on how to install or replace a memory module.

Your computer has two slots for installing or replacing DDR3 SODIMMs (small outline dual inline memory modules). When installing or replacing a memory module, use 1 gigabytes (GB) or 2 GB DDR3 SODIMMs in any combination up to a maximum of 4 GB of system memory.To install or replace a memory module, do the following:

  1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the computer.
  2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay it down so that the screen is against the surface and the cover is facing up.
  3. Remove the computer cover. See Removing the computer cover.
  4. Locate the memory slots. See Component locations.
  5. Open the retaining clips. If you are replacing an old memory module, open the retaining clips and remove the old memory module, as shown:

Removing the memory module

  1. Insert the notched end 2 of the new memory module into the slot 1. Press the memory module firmly and pivot the memory module until it snaps into place. Make sure that the memory module is secured in the slot and does not move easily.

Installing a memory module

  1. To complete the installation or replacement, go to Completing the parts replacement.

 



원하시는 내용을 찾을 수 없는 경우, 아래의 방법을 시도해 보십시오:
1. Lenovo 검색
2. 제품 사용 방법 및 일반적인 문제해결 방법
3. Lenovo 지원 포럼
4. 기술 지원 콜센터

국가 상태
사용 가능Worldwide
문서 자료 ID : HT037091
Legacy Document ID : MIGR-75320
마지막 업데이트 :
© 2013 Lenovo. All rights reserved.
   
Select Task
 
Drivers & Software  
Guides & Manuals  
Diagnose & Fix  
Warranty & Services  
Parts  
Accessories  

추가 자료
도움말 인덱스
제품 사양 - PSREF
드라이버 목록
새로 배포된 드라이버 (RSS)
커뮤니티
커뮤니티 기술자료
커뮤니티 포럼
Windows 8 Support