제품 정보를 입력하면, 맞춤형 서비스를 이용할 수 있습니다.
제품이 선택되지 않았습니다.제품을 선택하십시오.
Replacing the Bluetooth module - ThinkCentre M90z

Note: The Bluetooth module is available only in some models.

To replace the Bluetooth module, do the following:

  1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the computer.
  2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay it down so that the screen is against the surface and the cover is facing up.
  3. Remove the computer cover. See Removing the computer cover.
  4. Remove the rear I/O assembly cover. See Removing the rear I/O assembly cover.
  5. Locate the Bluetooth module in the computer. See Component locations.
  6. Note the Bluetooth module cable routing and disconnect the cable from the system board.
  7. Carefully release the Bluetooth module and lift the Bluetooth module out of the computer.

Removing the Bluetooth module

  1. Position the new Bluetooth module into the computer front bezel and then press the new Bluetooth module downward until it is secured into place.
  2. Connect the new Bluetooth module cable to the system board. See System board part and connector locations.
  3. Reinstall the rear I/O assembly cover. See Removing the rear I/O assembly cover.
  4. To complete the installation or replacement, go to Completing the parts replacement.

 



원하시는 내용을 찾을 수 없는 경우, 아래의 방법을 시도해 보십시오:
1. Lenovo 검색
2. 제품 사용 방법 및 일반적인 문제해결 방법
3. Lenovo 지원 포럼
4. 기술 지원 콜센터

국가 상태
사용 가능Worldwide
문서 자료 ID : HT035951
Legacy Document ID : MIGR-75327
마지막 업데이트 :
© 2013 Lenovo. All rights reserved.
   
Select Task
 
Drivers & Software  
Guides & Manuals  
Diagnose & Fix  
Warranty & Services  
Parts  
Accessories  

추가 자료
도움말 인덱스
제품 사양 - PSREF
드라이버 목록
새로 배포된 드라이버 (RSS)
커뮤니티
커뮤니티 기술자료
커뮤니티 포럼
Windows 8 Support