|LCD size and type||17.0-in (432-mm) LCD|
|Viewable image size||17.0 in/432 mm|
|Maximum viewable area||338 x 270 mm|
|Brightness (typical)||300 cd/m2|
|Contrast ratio (typical)||800 : 1|
|Viewing angle (typical)||Horizontal: +/- 70 degrees|
| ||Vertical: +/- 70 degrees|
|Cell response time (typical)||5 ms|
|RGB vertical stripe pixel pitch||0.264 mm|
|Video input||15-pin D and DVI|
|Tilt||5 degrees forward|
|20 degrees backward|
|Factory-preset display modes||23|
|SYNC on green||No|
|ISO 13406 Part 2||Yes|
|VESA DPMS power management capable||Yes|
|Power cord - detached||1.8 m|
|FCC B compliance||Yes|
|TCO'03 Environmental Label||Yes|
|Height||15.09 in (383.4 mm)||17.60 in (447 mm)|
|Width||14.63 in (371.6 mm)||17.60 in (447 mm)|
|Depth||7.48 in (190 mm)||5.51 in (140 mm)|
|Weight||8.36 lb (3.80 kg)||11.90 lb (5.40 kg)|
- Input voltage: 100 to 240 V ac +/- 10%
- Frequency: 50/60 Hz +/-3 Hz
- Power consumption:
- Normal use: <35 watts typical
- VESA Standby: <2 watt
- VESA Suspend: <2 watt
- VESA Off: <1 watt
- Maximum earth leakage current:
Note: Actual power consumption depends on the chosen display mode, the images displayed, and user control settings.
|Operating||0 to 40 deg.C||10 to 80 %||0 to 10,000 ft (3,000 m)|
|Shipping||-20 to 60 deg. C||5 to 95 %||0 to 15,000 ft (4,500 m)|
|Storage||-20 to 60 deg. C||5 to 95 %||0 to 15,000 ft (4,500 m)|
Declared acoustical noise emissions LWAU = 4.5 bels or less. The noise emission level stated is the declared (upper limit) A-weighted sound power level, in bels, for a random sample of monitors. All measurements are made in accordance with ANSI S12.10 and reported in conformance with ISO/DIS 7779.
- One monitor
- Tilt stand with customer-installed base
- Attached 1.8-meter analog video signal table (15-pin D to 15-pin D)
- Attached 1.8-meter audio cable
- Power cord
- CD containing multilingual user's guide, set-up test pattern, and .INF file
- Setup Poster
- Safety, Troubleshooting and Warranty Guide
Note: With the exception of the models for U.S., Canada, and Japan, the power cords (based on the country order code) are supplied by distribution centers.
Three years - Customer Carry-in or Mail-in using Rapid Replacement Service
- Announce date: 06 Jan 2009 (Brazil)
- Planned availability date: Jan 2009 (Brazil)
The display is intended to operate with system units or video adapters that generate a video output signal falling within the following specification:
|Maximum addressability (pixels)||1280 x 1024|
|Maximum pixel rate (MHz)||135|
The monitor supports VESA Standard Timings as detailed in Display Monitor Timing Specification, Version 1.0, Revision 0.8, dated September 17, 1998, for the following modes:
- VGA: 640 x 480 at 60, 72, and 75 Hz
- SVGA: 800 x 600 at 60, 72, and 75 Hz
- XGA: 1024 x 768 at 60, 70, and 75 Hz
- SXGA: 1280 x 1024 at 60, 70, and 75 Hz
This monitor also supports the following modes:
Note: National language support is a function of the video adapter in the system unit and the application or support software.
(H x V Pixels)
|Incoming video refresh rate|
|640 x 480||60 Hz|
|720 x 400||70 Hz|
|800 x 600||60 Hz|
|1024 x 768||60 Hz|
|1280 x 10241366 x 768||60 Hz|
The factory-preset modes cannot be overwritten, but can be adjusted to personal choice. The new settings are stored automatically in one of the user locations and are recalled each time that mode is used. The factory settings for the mode in use, if any, can be restored by operating the reset control.
Information about the current incoming display mode is shown in the on-screen displays. However, it is displayed at the LCD panel's optimum refresh rate of 60 Hz.
It may be necessary to make some adjustments to the displayed image to compensate for variations in video signal timings. The user controls can be used to make these adjustments.
The Lenovo D173 17-inch LCD Monitor is supplied with a detachable 1.8-meter video signal cable. This cable has the widely used 15-pin, D-Sub video connector for system unit connection.
This monitor has been tested with Lenovo 3000 systems and is compatible with systems and graphics adapters which comply with the relevant parts of VESA and industry standards and guidelines for computer display monitor timing Version 1.0 Revision 0.8, adopted September 17, 1998. Supported display modes and number of colors are a function of the attaching system unit. The full range of display modes, refresh rates, and number of colors available with this monitor may not be available or supported with all combinations of system units, their operating sytems, and application software. Implementation of monitor Plug and Play follows the VESA DDC standard. This standard must also be implemented in the attaching system unit hardware and software to be effective.
Plug and Play is a registered mark of Microsoft.
- Microsoft Windows 2000
- Microsoft Windows XP
- Microsoft Windows Vista Basic
- ENERGY STAR (U.S.)
- ISO 13406-Part 2
- Software: MS 2000/XP/Vista
UL (U.S.), IEC950 CB Report, FCC B (U.S.), TUV-S (Argentina)
- Supported display modes are a function of the attaching system unit and video subsystem. The full range of display modes available with these monitors may not be available or supported with all combinations of system units, their operating systems, video adapter cards, and application software.
- Horizontal- and vertical-synchronization signal timings are critical in order to achieve acceptable screen images. As a consequence, support for all possible variations in H- and V-sync timings for any display mode cannot be assumed.
- Adjustment of the user controls to enlarge the image to its maximum size requires that the signal timings of the display mode being used fall within the monitor-timing specifications.
- The number of colors shown in any display mode will be 16.7 million and is dependent on the capabilities of the video adapter in the system unit.
- The Lenovo D173 provides FCC class B - residential installation - compliance in all display modes.
- Implementation of monitor power management follows the VESA DPMS standard. This standard must also be implemented in the attaching system unit hardware and software for monitor power management to be effective. The system implementation must provide user-adjustable, power-down delay periods. The monitor power management function is invoked only after appropriate signals are received from an attached system unit or video adapter.
- Implementation of monitor Plug and Play follows the VESA DDC standard. This standard must also be implemented in the attaching system unit hardware and software for monitor Plug and Play to be effective.
- Certain functions require the system unit to be similarly configured, so all monitor functions may not be enabled when attached to a particular system unit.
- A 17.0-inch (432-mm) TFT monitor has nearly 4.0 million subpixel transistors laid over an area exceeding 141 square inches. Cost-effective manufacturing processes introduce a small number of defective subpixel transistors. The Lenovo D173 meets the ISO 13406-2 Class II Pixel Defect Standard.
- Use of 50% gray background is not recommended since some users may see undesirable FOS effects.
- The Auto-Setup test pattern can be used with Windows 3.1, Windows NT 3.5, Windows NT 4.0, Windows 95, Windows 98, Windows 2000, and DOS 7.0 only.