ExpressCache & IFFS Partition Recreation

Use this procedure if you are replacing an mSATA drive

  1. Determine which configuration your product supports (Cache only or Cache+IFFS)
  2. Install ExpressCache application in a Windows 7 system.(No mSATA attached)
  3. Copy the vbs files into any directory, e.g. c:\SWTOOLS\


Configuring the Partition:
  1. Plug mSATA into the unit (ExpressCache and vbs file ready).
  2. Run cmd.exe with administrator rights (start->all programs->accessories->command prompt)
  3. cd c:\SWTOOLS\ (go to your vbs directory )
  4. xxxx.vbs (input corresponding vbs file)
  5. Press Enter (warning message will popup if mSATA / ExpressCache is not ready or partition exists in mSATA)
  6. Reboot after successful information appears.



During the running of above vbs file, the following popup message may appear:

  1. "You have not installed Diskeeper ExpressCache, Please install the Software first"
    • Please install ExpressCache application first , then run the vbs file again.
  2. "There is NO mSATA detected, please check mSATA attached"
    • Please plug your mSATA device first, then run the vbs file again.
  3. "You have partitions on your mSATA device. Please back up and delete it"
    • Please run clean_msata.vbs first (same step as above vbs file), then run the previous vbs file again.


If you are unable to find what you are looking for, please do try the following options:
1. Lenovo Assisted Search
2. Product usage and general troubleshooting tips
3. Lenovo Support Forum
4. Technical Support Call Centre

Documento de identidad : HT073737
Última actualización :
© 2013 Lenovo. Todos los derechos reservados.
Seleccione Tarea
Controladores Y Software  
Guías Y Manuales  
Diagnosticar Y Reparar  
Garantía Y Servicios  

Driver Matrix
Artículos destacados de Knowledge Base
Centro de Respuestas de la Comunidad de Lenovo
Foros Comunidad de Lenovo
Lenovo Assisted Search