How to remove, add, and change a power on password - ThinkPad

How to set, remove or change a Power On Password on your IBM ThinkPad 365X, 380, 385, 560, 600, 750, 755, 760, 765, 770.

Note: Do not forget your Power On Password! If you forget your power-on password, you cannot reset it. You have to take the computer to an IBM authorized reseller or IBM marketing representative to have the password cancelled. Proof of purchase is required, and an additional charge might be required for the service.

Removing a power-on password
Remove the password by following the procedure below. This operation removes the Power-On password.

You must remove your password at the password prompt that appears when you turn on the computer. To remove the password, at the prompt, Enter your current password, press the Spacebar and then press Enter.

Setting a power-on password
  1. Start Easy-Setup by pressing and holding F1 and then turning on the computer.
  2. Select the Password, then select Power-On.
  3. Type your desired Power-On password, then press Enter. You can use any combination of up to 7 characters. Use a combination of any letters or numbers (A to Z, 0 to 9) in uppercase (A) or lowercase (a). Uppercase and lowercase letters are treated the same.
  4. Type your Power-On drive password again to verify it, the press Enter.


Note: When setting the password, the password screen will allow you to type in more than 7 characters. However, when entering in the password during boot up, it will only recognize the first 7 characters. If you type more than 7 characters, it will indicate that an invalid password was set. For example, if you set up the power-on password to be "MYFIRSTTP", when you were prompted to enter the password during boot up, it would only recognize "MYFIRST" as a valid password.

Changing a power-on password
  1. Turn off the computer and wait at least 5 seconds, then turn it on.
  2. When the Power-On drive password prompt appears, type your current Power-On drive password, then press Spacebar.
  3. Type the new password; then press the Spacebar. Use no more than 7 characters.
  4. Type the new password again to verify it, then press Enter.

    Note: This document applies to the X models of the 365 systems which are the following: 2E9,2R9,3E9,3R9,6E7,7E7.


If you are unable to find what you are looking for, please do try the following options:
1. Lenovo Assisted Search
2. Product usage and general troubleshooting tips
3. Lenovo Support Forum
4. Technical Support Call Centre

Documento de identidad : HT036658
Legacy Document ID : YAST-3JZNDP
Última actualización :
© 2013 Lenovo. Todos los derechos reservados.
   
Seleccione Tarea
 
Controladores Y Software  
Guías Y Manuales  
Diagnosticar Y Reparar  
Garantía Y Servicios  
Partes  
Accesorios  

RECURSOS ADICIONALES
Driver Matrix
COMUNIDAD
Artículos destacados de Knowledge Base
Centro de Respuestas de la Comunidad de Lenovo
Foros Comunidad de Lenovo
Lenovo Assisted Search