Choose Your Product
No Product SelectedSelect Product
ThinkVantage Access Connections will disable Windows Security Center firewall - ThinkPad General
Symptom
Installing Microsoft Windows XP Service Pack 2 enables Windows Firewall by default. However, Windows Security Center may show "CHECK STATUS" or "OFF" when ThinkVantage Access Connections is used to manage network location profiles. Even after Windows Firewall is enabled with Windows Security Center or Windows Firewall screen, ThinkVantage Access Connections may turn it off on boot or on switching network location profiles.

Affected configuration
Any of the following ThinkVantage ThinkPad systems with Access Connections and Microsoft Windows XP Service Pack 2 installed:
  • ThinkPad A20m, A20p, A21e, A21m, A21p, A22m, A22p, A22e
  • ThinkPad A30, A30p, A31, A31p
  • ThinkPad G40
  • ThinkPad R30, R31, R32
  • ThinkPad R40, R40e
  • ThinkPad R50, R50e, R50p, R51
  • ThinkPad s31
  • ThinkPad T20, T21, T22, T23
  • ThinkPad T30
  • ThinkPad T40, T40p, T41, T41p, T42, T42p
  • ThinkPad X20, X21, X22, X23, X24
  • ThinkPad X30, X31
  • ThinkPad X40
  • ThinkPad TransNote

Solution
Manually modify those network location profiles for which Windows Firewall should be enabled. Follow the steps shown below to modify the Windows Firewall setting in a network location profile of ThinkVantage Access Connections.

1. Open "ThinkVantage Access Connections" program from Start menu

A. Click the Start button
B. Select All programs (or Programs with the classic start menu)
C. Select Access IBM
D. Click ThinkVantage Access Connections

2. On the "Connection Status" screen, click the Manage Location Profiles button

3. Choose and highlight a location profile you want to modify.

4. Click the Edit button

5. On the Modify profile: profile name screen, click the Security tab
Where, profile name indicates the name of location profile you chose at the step 3

6. On the Security tab, check the checkbox for Protect my computer and network by limiting or preventing access to this computer from the Internet (Internet Connection Sharing).

7. Click the OK button to save the change

8. Click the Close button

9. Repeat from Step 2 to 8 above for all the network location profiles you want to enable Windows Firewall

Note: The above steps were written based on ThinkVantage Access Connections Version 3.10. With other versions of ThinkVantage Access Connections, steps may vary.

Additional information
From the introduction of Microsoft Windows XP Service Pack 2, Microsoft changes the default state of Windows Firewall to "Enabled". While, ThinkVantage Access Connections disables Windows Firewall by default except for profiles connecting to a public wireless access point (e.g. hot-spot).


If you are unable to find what you are looking for, please do try the following options:
1. Lenovo Assisted Search
2. Product usage and general troubleshooting tips
3. Lenovo Support Forum
4. Technical Support Call Centre

Country Availability
AvailableWorldwide
Document ID : HT035466
Legacy Document ID : MIGR-56740
Last Updated : 27 Mar 2014
Copyright © Lenovo 2013, all rights reserved
Was this page helpful to you?YesNo


   
Select Task
 
Drivers & Software  
Guides & Manuals  
Diagnose & Fix  
Warranty & Services  
Parts  
Accessories  

ADDITIONAL RESOURCES
Driver Matrix
COMMUNITY
KnowledgeBase Featured Articles
Community KnowledgeBase
Community Forums
Lenovo EMC
Windows 8 Support