Choose Your Product
No Product SelectedSelect Product
Heat sink removal and installation - ThinkStation D20 (type 4155, 4158, 4218)

CAUTION:
caution
The heat sink and microprocessor might be very hot. Turn off the computer and wait three to five minutes to let the computer cool before opening the computer cover.

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information" in the ThinkStation Safety and Warranty Guide that came with your computer.

This section provides instructions on how to replace and install the heat sink.

To replace the heat sink:

  1. Open the computer cover. See "Cover removal".
  2. Lay the computer on its side for easier access to the heat sink.
  3. Remove the heat sink and fan assembly cables from the system board. Note the cable location. See "Locating parts on the system board".
  4. Follow this sequence to remove the heat sink from the system board:
    • Partially remove screw (1), then fully remove screw (2), and fully remove screw (1).
    • Partially remove screw (3), then fully remove screw (4), and fully remove screw (3).

screw locations

  1. Carefully lift the heat sink off of the system board.
  2. Remove the plastic cover from the bottom of the new heat sink to expose the heat sink grease (this cover protects the heat sink grease from contamination).
    Notes:
    1. Do not remove the plastic cover until you are ready to install the heat sink and fan assembly on the microprocessor. Do not touch the grease on the heat sink and fan assembly. Do not put the heat sink and fan assembly anywhere except on the microprocessor after the plastic cover has been removed and the grease exposed.
    2. Some heat sink part numbers will have orientation labels showing "Front of System." Heat Sinks that do not have orientation labels should be oriented so the fan cable is toward the board connector labeled "CPU Fan."
  3. Place the new heat sink into position.
    Important: Do not touch the thermal grease while handling the heat sink.
  4. Align the four screws on the heat sink with the four mounting studs in the chassis.
  5. Follow this sequence to install the screws, noting that fully tight is 5 in-lbs +/- 0.5 in-lbs:
    • a. Partially tighten screw (1), then fully tighten screw (2), and fully tighten screw (1).
    • b. Partially tighten screw (3), then fully tighten screw (4), and fully tighten screw (3).
  6. Reconnect the heat sink fan cable. See "Locating parts on the system board".
  7. Go to "Completing the FRU replacement".
Purchase parts online


If you are unable to find what you are looking for, please do try the following options:
1. Lenovo Assisted Search
2. Product usage and general troubleshooting tips
3. Lenovo Support Forum
4. Technical Support Call Centre

Country Availability
AvailableWorldwide
Document ID : PD010863
Legacy Document ID : MIGR-72124
Last Updated :
Copyright © Lenovo 2013, all rights reserved
Was this page helpful to you?YesNo


   
Select Task
 
Drivers & Software  
Guides & Manuals  
Diagnose & Fix  
Warranty & Services  
Parts  
Accessories  

ADDITIONAL RESOURCES
Support Help Index
Warranty Lookup
Product Detail
Technical Specifications - PSREF
Driver Matrix
COMMUNITY
KnowledgeBase Featured Articles
Community KnowledgeBase
Community Forums
Lenovo EMC
Windows 8 Support