Memory removal and installation - NetVista 2289, 6824
Memory installation

Your computer has two connectors for installing dual inline memory modules
(DIMMs) that provide up to a maximum of 2.0 GB of system memory.
When installing DIMMs, the following rules apply:
  • Fill each system memory connector sequentially, starting at DIMM connector 1.
  • Use 2.5 V, 184-pin, 266MHz double data rate synchronous dynamic random
    access memory (DDR SDRAM).
  • Use 128 MB, 256 MB, 512 MB, or 1.0 GB (when available) DIMMs in any
    combination.
  • DIMMs are 38.1 mm (1.5 inches) in height.
    Note: Only DDR SDRAM DIMMs can be used.


DIMM installation

  1. Remove the cover. See Cover removal.
  2. You might have to remove an adapter to gain access to the DIMM slots. See
    Adapter installation.
  3. To locate the DIMM connectors. See Identifying parts on the system board.
  4. Open the retaining clips.

    opening memory slot

  5. Make sure the notches in the DIMM align with the tabs on the connector. Push
    or insert the DIMM straight down into the connector until the retaining clips
    close.

    inserting memory in the slot
Purchase parts online


If you are unable to find what you are looking for, please do try the following options:
1. Lenovo Assisted Search
2. Product usage and general troubleshooting tips
3. Lenovo Support Forum
4. Technical Support Call Centre

Country Availability
AvailableWorldwide
Document ID : PD008922
Legacy Document ID : MIGR-42933
Last Updated :
Copyright © Lenovo 2013, all rights reserved
Was this page helpful to you?YesNo


   
Select Task
 
Drivers & Software  
Guides & Manuals  
Diagnose & Fix  
Warranty & Services  
Parts  
Accessories  

ADDITIONAL RESOURCES
Driver Matrix
COMMUNITY
KnowledgeBase Featured Articles
Community KnowledgeBase
Community Forums